Home   |   New Vehicles   |   Used Vehicles   |   Leasing   |   Photo Gallery   |   Parts/Accessories   |   Service   |   About Us   |   Locations   |   Contact Us

 


EZ GO Shuttle 2 Electric

Product Specification
 

Motor: 48 volt DC shunt wound, brazed armature, solid copper windings.
15.2 hp (11.3 kW) at 1600 RPM.
Drive Train:  Direct motor shaft connected to transaxle pinion shaft.
Electrical System: 48 volt DC, eight, 6 volt deep cycle storage batteries (115 minute minimum,225 amp-hour@ 20 Hr. discharge rate). Dash mounted direction selector switch (Forward – Neutral – Reverse)
Speed Control: Precision Drive System - Solid state continuously variable separately excited speed controller. 350 Amp capacity. Inductive throttle sensor
Precision Drive System: Anti-roll back, anti–stall, walk away, high pedal disable features. Run
Tow /
Maintenance switch. Diagnostic fault mode
Charger: Fully automatic line compensating, 21 amp DC output at 48 volts;
input 110-120 volts, 60 cycle AC
Transaxle: Differential with helical gears, 14.7:1 ratio.
Brakes: Dual rear wheel mechanical self-adjusting drum brakes. Automatic
park brake release with self-compensating system. Hydraulic front
disc brakes
Front Suspension: Leaf springs with hydraulic shock absorbers.
Rear Suspension: Leaf springs with hydraulic shock absorbers.
Steering: Self-compensating single reduction rack and pinion.
Speed: 13 mph ± 0.5 mph (21 kph ± 0.8 kph)
Weight: 810 lb (370 kg), (without batteries)
Ground Clearance: 4.25 in (10.8 cm) (at differential)
Length: 133 in (338 cm)
Width: 46.5 in (118 cm)
Height: 48.6 in (123 cm) (top of steering wheel)
Top Height: 73.0 in (185 cm)
Wheel Base: 93.5 in (237 cm)
Front Wheel Tread: 33.5 in (85 cm)
Rear Wheel Tread: 38.0 in (97 cm)
Cargo Bed: 44 in wide x 68.5 in long (112 cm W x 174 L cm)
Turning Circle Dia: 29 ft (8.8m)
Load Capacity: 1,200 lb (540 kg) including operator, passenger, accessories, and cargo
Seating: Vacuum formed fabric backed vinyl covers over cushion foam. Standard seating for operator and one passenger
Body: Front: Injection molded TPE (Thermoplastic Elastomer) Rear: Steel panels
 
 
Professional Golfcar Corporation
2370 W. Fullerton Pike
Bloomington, IN 47403
 
Phone: 800-742-4064     Fax: 812-825-9409